This MedLibrary.org supplementary page on Atomic hydrogen welding is provided directly from the open source Wikipedia as a service to our readers. Please see the note below on authorship of this content, as well as the Wikipedia usage guidelines. To search for other content from our encyclopedia supplement, please use the form below:
Related Sponsors
Atomic hydrogen welding (AHW) is an arc welding process that uses an arc between two metal tungsten electrodes in a shielding atmosphere of hydrogen. The process was invented by Irving Langmuir in the course of his studies of atomic hydrogen. The electric arc efficiently breaks up the hydrogen molecules, which later recombine with tremendous release of heat, reaching temperatures from 3400 to 4000 °C. An acetylene torch merely reaches 3300 °C. This is the third hottest flame after cyanogen at 4525 °C and dicyanoacetylene at 4987 °C. This device may be called an atomic hydrogen torch, nascent hydrogen torch or Langmuir torch. The process was also known as Arc-Atom welding.
The heat produced by this torch is sufficient to melt and weld tungsten (3422 °C), the most refractory metal. The presence of hydrogen acts as a gas shield and protects metals from contamination by carbon, nitrogen, or oxygen, which can severely damage the properties of many metals. It eliminates the need of flux for this purpose.
The arc is maintained independently of the workpiece or parts being welded. The hydrogen gas is normally diatomic (H2), but where the temperatures are over 600 °C (1100 °F) near the arc, the hydrogen breaks down into its atomic form, simultaneously absorbing a large amount of heat from the arc. When the hydrogen strikes a relatively cold surface (i.e., the weld zone), it recombines into its diatomic form and rapidly releases the stored heat. The energy in AHW can be varied easily by changing the distance between the arc stream and the workpiece surface. This process is being replaced by shielded metal-arc welding, mainly because of the availability of inexpensive inert gases.
In atomic hydrogen welding, filler metal may or may not be used. In this process, the arc is maintained entirely independent of the work or parts being welded. The work is a part of the electrical circuit only to the extent that a portion of the arc comes in contact with the work, at which time a voltage exists between the work and each electrode.
References
- Norton science encyclopedia 1st and 6th edition copyright 1921-1950 and 1976
- Van Nostrand's Encyclopedia of Science (Pg. 1311)
- Welding Handbook Vol. 2 Library of Congress number 90-085465 copyright 1991 by American Welding Society
- Kalpkjian, Serope and Steven R. Schmid. Manufacturing Engineering and Technology textbook Fifth edition. Upper Saddle River: Pearson Education, Inc., 2006
- "Atomic Hydrogen Welding". Specialty Welds. Retrieved on 2008-01-26.
- "Atomic - Hydrogen Welding". Odhams Practical & Technical Encyclopaedia. (1947). Retrieved on 2008-01-26.
- "Atomic Hydrogen Blowtorch". Lateral Science. Retrieved on 2008-01-26.
|
||||||||||||||||||||
Wikipedia content modification information:
- This page was last modified on 6 November 2008, at 18:13.
Wikipedia Authorship and Review
Wikipedia content provided here is not reviewed directly by MedLibrary.org. Wikipedia content is authored by an open community of volunteers and is not produced by or in any way affiliated with MedLibrary.org.
Wikipedia Usage Guidelines
This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article on "Atomic hydrogen welding".
The URL for this specific entry is:
All Wikipedia text is available under the terms of the GNU Free Documentation License. (See Copyrights for details). Wikipedia® is a registered trademark of the Wikimedia Foundation, Inc.