IPRIVASK- desirudin
Valeant Pharmaceuticals North America LLC


When neuraxial anesthesia (epidural/spinal anesthesia) or spinal puncture is employed, patients anticoagulated or scheduled to be anticoagulated with selective inhibitors of thrombin such as Iprivask may be at risk of developing an epidural or spinal hematoma which can result in long-term or permanent paralysis.

The risk of these events may be increased by the use of indwelling spinal catheters for administration of analgesia or by the concomitant use of drugs affecting hemostasis such as non-steroidal anti-inflammatory drugs (NSAIDs), platelet inhibitors, or other anticoagulants. Likewise with such agents, the risk appears to be increased by traumatic or repeated epidural or spinal puncture.

Patients should be frequently monitored for signs and symptoms of neurological impairment. If neurological compromise is noted, urgent treatment is necessary.

The physician should consider the potential benefit versus risk before neuraxial intervention, in patients anticoagulated or to be anticoagulated for thromboprophylaxis [ see Warnings and Precautions (5.1) ] .


Iprivask is indicated for the prophylaxis of deep vein thrombosis, which may lead to pulmonary embolism, in patients undergoing elective hip replacement surgery.


2.1 Recommended Dose

All patients should be evaluated for bleeding disorder risk before prophylactic administration of Iprivask [ see Drug Interactions (7.1) ] .

Initial Dosage: In patients undergoing hip replacement surgery, the recommended dose of Iprivask is 15 mg every 12 hours administered by subcutaneous injection with the initial dose given up to 5 to 15 minutes prior to surgery, but after induction of regional block anesthesia, if used [ see Warnings and Precautions (5.1)] . Up to 12 days administration (average duration 9 to 12 days) of Iprivask has been well tolerated in controlled clinical trials.

2.2 Dose Adjustment in Renal Impairment

Degree of Renal Impairment



[mL/min/1.73m 2 body surface area]

aPTT Monitoring & Dosing Instructions


>31 to 60

Initiate therapy at 5 mg every 12 hours by subcutaneous injection. Monitor aPTT and serum creatinine at least daily. If aPTT exceeds 2 times control:

  • Interrupt therapy until the value returns to less than 2 times control.
  • Resume therapy at a reduced dose guided by the initial degree of aPTT abnormality

Severe a


Initiate therapy at 1.7 mg every 12 hours by subcutaneous injection. Monitor aPTT and serum creatinine at least daily. If aPTT exceeds 2 times control:

  • Interrupt therapy until the value returns to less than 2 times control.
  • Consider further dose reductions guided by the initial degree of aPTT abnormality

a See Clinical Pharmacology (12.3) and Warnings and Precautions (5.3).

Clinical Monitoring

Activated partial thromboplastin time (aPTT) should be monitored daily in patients with increased risk of bleeding and/or renal impairment. Serum creatinine should be monitored daily in patients with renal impairment. Adjust Iprivask dosage according to creatinine levels [ see Dosage and Administration (2.2) ] .

Peak aPTT should not exceed two times control. Should peak aPTT exceed this level, reduce the dosage of Iprivask based on the degree of aPTT abnormality [ see Dosage and Administration (2.2) ] . If necessary, interrupt therapy with desirudin until aPTT falls to less than two times control, at which time treatment with desirudin can be resumed at a reduced dose. Thrombin time (TT) is not a suitable test for routine monitoring of Iprivask therapy [ see Clinical Pharmacology (12.2) ].

Conversion from Other Anticoagulants

If a patient is switched from oral anticoagulants to Iprivask therapy or from Iprivask to oral anticoagulants, the anticoagulant activity should continue to be closely monitored with appropriate methods [ see Drug Interactions (7.1) ] .

Instructions for Administration

Directions on Preparation

Use Iprivask before the expiration date given on the carton and container.

  • To prepare the reconstituted aqueous solution, 0.5 mL of the mannitol diluent is added under aseptic conditions to the vial containing the sterile powder.
  • Remove plastic flip-top cap from Iprivask Vial. Remove back cover of Vial Adapter package. Attach Vial Adapter to Vial by using the outer package to handle Adapter. Push Adapter down onto Vial until spike pierces rubber stopper and snaps into place. Discard Vial Adapter package.
  • Remove Syringe cap by twisting and pulling gently. Attach Syringe to Adapter on Vial by twisting. Slowly push plunger down to completely transfer solution into Vial. Leaving Syringe connected to Vial, gently swirl. Lyophilized powder in Vial will dissolve within 10 seconds.
  • With Syringe still connected to Vial, turn Vial upside down and withdraw entire contents of Vial back into Syringe. Remove Syringe from Vial and hold it with plunger-end down.
  • You must use enclosed Eclipse™ needle. Attach Needle to Syringe by twisting. Pull pink lever down and uncap needle. You are ready to inject Iprivask. After injection, flip up pink lever to cover needle until it snaps into place. Dispose of the used Syringe in a Sharps ® container.

Iprivask should not be mixed with other injections, solvents, or infusions. Iprivask is administered by subcutaneous injection. It must not be administered by intramuscular injection.

Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

Subcutaneous Injection Technique:

Patients should be sitting or lying down and Iprivask injection administered by deep subcutaneous injection. Administration should be alternated between the left and right anterolateral and left and right posterolateral thigh or abdominal wall. The whole length of the needle should be introduced into a skin fold held between the thumb and forefinger; the skin fold should be held throughout the injection. To minimize bruising, do not rub the injection site after completion of the injection.

Storage after Reconstitution

Once Iprivask is reconstituted it may be used for up to 24 hours, when stored at 25°C (77°F); excursions permitted to 15° to 30°C (59° to 86°F)[See USP Controlled Room Temperature]. Protect from light. After 24 hours, discard the solution.


Iprivask (desirudin for injection) is supplied as a single dose (15.75 mg) lyophilized powder with an accompanying sterile, non-pyrogenic diluent [0.6 mL of Mannitol USP (3%) in Water for Injection]. The reconstituted solution delivers 15 mg of Iprivask in 0.5 mL.


Iprivask is contraindicated in patients with known hypersensitivity to natural or recombinant hirudins due to risk of anaphylaxis, and in patients with active bleeding and/or irreversible coagulation disorders due to risk of hemorrhage.

All MedLibrary.org resources are included in as near-original form as possible, meaning that the information from the original provider has been rendered here with only typographical or stylistic modifications and not with any substantive alterations of content, meaning or intent.

This site is provided for educational and informational purposes only, in accordance with our Terms of Use, and is not intended as a substitute for the advice of a medical doctor, nurse, nurse practitioner or other qualified health professional.

Privacy Policy | Copyright © 2020. All Rights Reserved.