Technetium Tc 99m Medronate (Page 2 of 2)

ADVERSE REACTIONS

Several cases of allergic dermatological reactions have been reported in association with the use of Technetium Tc 99m Medronate.
Several reactions have also been reported in association with other radiopharmaceuticals of the diphosphonate class, particularly Technetium Tc 99m Medronate. These are usually hypersensitivity reactions characterized by itching, various skin rashes, hypotension, chills, nausea, fever, and vomiting. One death secondary to cardiac arrhythmia following the administration of Technetium Tc 99m Medronate has been reported. In addition, one case of cardiac arrest in a patient also undergoing pulmonary function testing one and one-half hours after the performance of a bone scan using Technetium Tc 99m Medronate has been reported.

DOSAGE AND ADMINISTRATION

The recommended adult dose, after reconstitution with oxidant-free sodium pertechnetate Tc-99m, is 370 to 740 megabecquerels (10 to 20 millicuries [200 µCi/kg]) by slow intravenous injection over a period of 30 seconds. Optimum scanning time is 1 to 4 hours post-injection.
To minimize the contribution of the bladder content to the image, the patient should void immediately before imaging is started.
The patient dose should be measured by a suitable radioactivity calibration system immediately prior to administration.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration. The
solution should not be used if cloudy.
RADIATION DOSIMETRY
The estimated absorbed radiation doses to an average patient (70 kg) from an intravenous injection of a maximum dose of 740 megabecquerels (20 millicuries) of Technetium Tc 99m Medronate are shown in Table 4. The effective half-life was assumed to be the physical half-life for all calculated values.

Table 4 Radiation Doses2

2 Method of calculation: “S” Absorbed Dose per Unit Cumulated Activity for Selected Radionuclides and Organs, MIRD Pamphlet No. 11, 1975
Tissue

Absorbed Radiation Dose

mGy/740 MBq

rads/20 mCi

Total Body

Total Bone

Red Marrow

Kidneys

Liver

Bladder Wall

2 hr. void

4.8 hr. void

Ovaries

2 hr. void

4.8 hr. void

Testes

2 hr. void

4.8 hr. void

1.3

7.0

5.6

8.0

0.6

26.0

62.0

2.4

3.4

1.6

2.2

0.13

0.70

0.56

0.80

0.06

2.60

6.20

0.24

0.34

0.16

0.22

HOW SUPPLIED

MDP-25,
Kit for the Preparation of Technetium Tc 99m Medronate Injection
Product No. 500661 (30 vials)
Available in boxes consisting of 30 reaction vials, each vial containing in lyophilized form, sterile and non-pyrogenic:
Medronic Acid 25.0 mg
Stannous Chloride Dihydrate (minimum) 2.0 mg
(Maximum tin as stannous chloride dihydrate) 3.0 mg
p-Aminobenzoic Acid 5.0 mg
The pH is adjusted to 6.8 to 6.9 with HCI or NaOH prior to lyophilization. The vials are sealed under an atmosphere of nitrogen.
Radioassay information labels with radiation warning symbol and a package insert are supplied in each box.

STORAGE

Store the unreconstituted reaction vials at 25ºC (77ºF); excursions permitted between 15° and 30ºC (59° to 86ºF). After labeling with Technetium Tc-99m, the reconstituted product should be stored at 25ºC (77ºF) in the original vial, and be placed in a suitable lead shield. Excursions permitted between 15° and 30ºC (59° to 86ºF). Discard the reconstituted solution after 12 hours.

DIRECTIONS

NOTE: Use aseptic procedures throughout and take precautions to minimize radiation exposure by use of suitable shielding. Use waterproof gloves during the following preparation procedure.
MDP-25 reaction vials are intended for the preparation of multiple doses of Technetium Tc 99 Medronate and the entire contents of the vial should not be used as a single dose.
Before reconstituting a vial, it should be inspected for cracks and/or a melted plug or any other indication that the integrity of the vacuum seal has been compromised.
To prepare Technetium Tc 99m Medronate:

  1. Remove the central metal disc from a reaction vial and swab the closure with either an alcohol swab or a suitable bacteriostatic agent.

  2. Place the reaction vial in a suitable lead vial shield (minimum wall thickness 1/8 inch) which has a fitted lead cap. Obtain 2 to 10 mL of sterile, non-pyrogenic sodium pertechnetate Tc-99m, using a shielded syringe.

    The recommended maximum amount of Technetium Tc-99m to be added to a reaction vial is 37.0 gigabecquerels (1000 mCi). Sufficient sodium pertechnetate is to be used for the reconstitution of a reaction vial to ensure that the dose of medronate administered does not exceed 10 mg. Sodium pertechnetate Tc-99m solutions containing an oxidizing agent are not suitable for use.

  3. Using a shielded syringe, add the sodium pertechnetate Tc-99m solution to the reaction vial aseptically.

  4. Place the lead cap on the reaction vial shield and agitate the shielded reaction vial until the contents are completely dissolved. The solution must be clear and free of particulate matter before proceeding.

  5. Assay the product in a suitable calibrator, record the radioassay information on the label with radiation warning symbol, and apply it to the reaction vial.

  6. Withdrawals for administration must be made aseptically using a shielded sterile syringe and needle. Since the reaction vials contain nitrogen to prevent oxidation of the complex, they should not be vented. If repeated withdrawals are made, minimize the replacement of contents with room air.

The following steps should be followed to ensure that each reconstituted of Technetium Tc 99m Medronate contains between 1 and 10 mg of medronic acid.
Where:
Vr = Final volume of in the vial in mL after reconstitution.
C = Concentration of Medronic Acid in mg/mL.
Max. V = Maximum volume to be used for one dose in mL.
Min. V = Minimum volume to be used for one dose in mL.

  1. Prior to reconstitution, determine the radioactive concentration of the sodium pertechnetate Tc-99m.

  2. Note the volume and activity added to the vial. It should be between 1.85 – 37.0 GBq (50 – 1000 mCi) in 1 to 10 mL.

  3. Calculate the concentration (C) of Medronic acid in the vial after reconstitution.

    C (mg/mL) = 25 mg ÷ Vr (mL)

  4. To ensure that the dose contains a maximum of 10 mg, the following formula should be used to calculate the maximum volume (Max. V) to be dispensed as one dose.

    Max. V (mL) = 10 mg ÷ C (mg/mL)

  5. To ensure that a minimum dose of 1 mg is dispensed, the following formula should be used to calculate the minimum volume (Min. V) to be dispensed as one dose

    Min. V = 1mg ÷ C(mg/mL)

7. The finished preparation should be stored at 25ºC (77ºF);excursions permitted between 15° and 30ºC (59° to 86ºF) when not in use and discarded after 12 hours. It should also be stored during its life in a suitable lead shield.

This reagent kit is approved by the U.S. Nuclear Regulatory Commission for distribution to persons licensed to use by-product material identified in §35.200 to 10 CFR Part 35, to persons who have a similar authorization issued by an Agreement State, and, outside the United States, to persons authorized by the appropriate authority.

Manufactured by:
Jubilant DraxImage Inc.
Kirkland Quebec, H9H 4J4 Canada. Revised: October 2011

PRINCIPAL DISPLAY PANEL

image 1
(click image for full-size original)
image 1
(click image for full-size original)
image 2
(click image for full-size original)
TECHNETIUM TC 99M MEDRONATE technetium tc 99m medronate injection, powder, for solution
Product Information
Product Type HUMAN PRESCRIPTION DRUG Item Code (Source) NDC:65174-660
Route of Administration INTRAVENOUS DEA Schedule
Active Ingredient/Active Moiety
Ingredient Name Basis of Strength Strength
MEDRONIC ACID (MEDRONIC ACID) MEDRONIC ACID 25 mg
Inactive Ingredients
Ingredient Name Strength
Stannous Chloride 2.0 mg
Aminobenzoic Acid 5.0 mg
Packaging
# Item Code Package Description Multilevel Packaging
1 NDC:65174-660-30 30 INJECTION, POWDER, FOR SOLUTION in 1 CARTON None
Marketing Information
Marketing Category Application Number or Monograph Citation Marketing Start Date Marketing End Date
NDA NDA018035 02/27/2004
Labeler — Jubilant DraxImage Inc., dba Jubilant Radiopharma (243604761)
Registrant — Jubilant Draximage Inc., dba Jubilant Radiopharma (243604761)
Establishment
Name Address ID/FEI Operations
Jubilant HollisterStier General Partnership 246762764 MANUFACTURE (65174-660)

Revised: 08/2020 Jubilant DraxImage Inc., dba Jubilant Radiopharma

Page 2 of 2 1 2

All MedLibrary.org resources are included in as near-original form as possible, meaning that the information from the original provider has been rendered here with only typographical or stylistic modifications and not with any substantive alterations of content, meaning or intent.

This site is provided for educational and informational purposes only, in accordance with our Terms of Use, and is not intended as a substitute for the advice of a medical doctor, nurse, nurse practitioner or other qualified health professional.

Privacy Policy | Copyright © 2024. All Rights Reserved.